MAGDALENA

The design-shaped bathroom radiator with an exceptional appearance is made of chrome-plated steel pipes. The radiator can be hung on both sides.

Heating options:

Combination of central and electric heating

Electrical heating

Central heating

Side ladder connection options

1. Central heating - manual valve

CUBE set COMPACT set Copper fittings ALU fittings Cover caps

If you decide to buy a ladder of this type, you need to choose a suitable connection set.

If the heating is to be used only for hot water heating without a thermostatic head, it is necessary to buy a connection set
eg COMPACT or CUBE (depending on the heating design).
The CUBE set is available in chrome, brushed stainless steel or silver.
The COMPACT set is only available in chrome. The COMPACT and CUBE sets do not distinguish between the right / left variants.
ADVICE! Holes for pipes in tiles are not always perfectly designed, so we recommend purchasing a set of cover rosettes.
Covering rosettes are used to cover Cu or Alupex pipes and openings in the wall.
Cover rosettes are available in chrome or brushed stainless steel.
ATTENTION! Our design valves have a special thread of 24-19 and therefore it is necessary to buy each valve recommended by us
compression fittings according to material and pipe diameter - copper / alupex.
Compression fittings are available in chrome or brushed stainless steel.


2. Central heating - valve with thermostatic head

Set CORNER Fitting copper Fitting ALU Covering rosettes

If you decide on the thermostatic version, we recommend the design CORNER :
ADVICE! Set CORNER is available in right / left version. The picture above shows the right variant - the hot water supply is on the right, also the thermo head itself is located on the right (always in front view). It is recommended to select the valve so that the head always points in the direction of the horizontal profiles of the heating element and not to the opposite side (outside the heating). The triaxial design of the valve makes it possible to hide the valve head under the radiator and thus does not take up space.
Set CORNER available in chrome or brushed stainless steel.
ATTENTION! The above mentioned compression fittings for heating assembly + cover rosettes. Available in chrome or brushed stainless steel.
Cover rosettes are available in chrome or brushed stainless steel.


3. Combined heating - valve with thermostatic head

Corner COMBI Heating rod Copper fittings ALU fittings Rosettes

If you decide to use the heating for both hot water and electric heating, we recommend the CORNER COMBI + heating rod connection set :

ADVICE! The heating rod can be retrofitted, but we do not recommend this option because of the probable necessity of removing the heating ladder and draining the heating circuit. For heating rod selection, see option 4.
ATTENTION! Again, it is necessary to select the right variant of the left / right valve design, see above.
The CORNER COMBI set is available in chrome or brushed stainless steel.
ATTENTION! Compression fitting + cover rosettes.
Available in chrome or brushed stainless steel. Cover rosettes are available in chrome or brushed stainless steel.


4. Electric heating - with thermostatic heating rod

When choosing electric heating we offer a wide selection of heating rods - ONE, ONE -D, MOA, KTX, GV ...
ADVICE! The client chooses the heating rod according to his own taste, design and performance!
ATTENTION! The heating rod must be of adequate output as specified by the heating element or the nearest lower possible.

If the heater is only electrically heated, it must be filled with antifreeze anticorrosive heat transfer fluid such as LIKIDO . It is also necessary to buy a ½ "radiator plug.

Products in series